LTM8020
OPERATION
The LTM8020 is a standalone nonisolated step-down
switching DC/DC power supply. It can deliver up to
200mA of DC output current with only bulk external input
and output capacitors. This module provides a precisely
regulated output voltage programmable via one external
resistor from 1.25VDC to 5VDC. The input voltage range
is 4V to 36V. Given that the LTM8020 is a step-down con-
verter, make sure that the input voltage is high enough to
support the desired output voltage and load current. See
Block Diagram.
The LTM8020 contains a current mode controller, power
switching element, power inductor, power Schottky diode
and a modest amount of input and output capacitance.
For some applications, as shown in Table 1, no output
capacitor is necessary.
With its high performance current mode controller and
internal feedback loop compensation, the LTM8020 module
has sufficient stability margin and good transient perfor-
mance under a wide range of operating conditions with a
wide range of output capacitors, even all ceramic ones (X5R
or X7R). Current mode control provides cycle-by-cycle fast
current limit, and automatic current limiting protects the
module in the event of a short circuit or overload fault.
200mA LOAD
V OUT
20mV/DIV
The LTM8020 is built upon a variable frequency control-
ler. The on time, off time and switching frequency are
dependent upon the input voltage, output voltage and
load current.
The drive circuit for the internal power switching element
is powered through the BIAS pin. Power this pin with at
least 3V.
The LTM8020 is equipped with two operating modes,
dependant upon the load current. When the load current
is sufficiently high, the LTM8020 will switch continuously
(see Figure 1a). If the load is very light, or if the input
voltage is high relative to the output voltage, the part will
operate in Burst Mode ? operation, alternating between its
micropower and switching states to keep the output in
regulation and hold the power dissipation to a minimum
(See Figure 1b).
If the SHDN pin is grounded, all internal circuits are turned
off and V IN current reduces to the device leakage current,
typically a few nanoamps.
NO LOAD
V OUT
20mV/DIV
I L
100mA/DIV
I L
100mA/DIV
V OUT
20mV/DIV
I L
100mA/DIV
150mA LOAD
1μs/DIV
V OUT
20mV/DIV
I L
100mA/DIV
10mA LOAD
1ms/DIV
1μs/DIV
(1a) Continuous Operation
8020 F1a
5μs/DIV
(1b) Burst Mode Operation
8020 F01b
Figure 1. Output Voltage and Internal Inductor Current
8020fd
7
相关PDF资料
LTM8023MPV#PBF IC BUCK SYNC ADJ 2A 50LGA
LTM8025MPV#PBF IC CONVERTER BUCK 3A ADJ 70LGA
LTM8026MPV#PBF IC UMODULE 36VIN 5A CVCC 81LGA
LTM8027EV#PBF IC BUCK SYNC ADJ 4A 113LGA
LTM8032MPY#PBF IC DC/DC UMODULE 2A 71BGA
LTM8033MPV#PBF IC DC-DC UMODULE BUCK 3A 76-LGA
LTM8040IV#PBF IC LED DRVR HP CONST CURR 66-LGA
LTM8042IV#PBF IC UMODULE LED DRIVER 56LGA
相关代理商/技术参数
LTM8020IV#PBF 制造商:Linear Technology 功能描述:DC/DC Controller LTC 制造商:Linear Technology 功能描述:IC, DC/DC MOD REGULATOR, 450kHz, LGA-21
LTM8020IVPBF 制造商:Linear Technology 功能描述:200mA 36V DC/DC uModule Regulator LGA21
LTM8020IV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:200mA, 36V DC/DC μModule
LTM8020MPV 制造商:LINER 制造商全称:Linear Technology 功能描述:200mA, 36V DC/DC μModule
LTM8020MPV#PBF 功能描述:IC DC/DC UMODULE 200MA 21-LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 特色产品:VYB Series High Efficiency Converters 3D 型号:VYB15W-Q48-S15 标准包装:63 系列:V-Infinity VYB15W 类型:隔离 输出数:1 电压 - 输入(最小):18V 电压 - 输入(最大):75V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):1A 电源(瓦) - 制造商系列:15W 电压 - 隔离:1.5kV(1500V) 特点:具有远程开/关功能和 UVLO 安装类型:通孔 封装/外壳:6-DIP 模块 尺寸/尺寸:2.00" L x 1.00" W x 0.44" H(50.8mm x 25.4mm x 11.3mm) 包装:管件 工作温度:-40°C ~ 85°C 效率:85% 电源(瓦特)- 最大:15W 其它名称:102-2329656-91325R
LTM8020MPV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:200mA, 36V DC/DC μModule
LTM8020V 制造商:LINER 制造商全称:Linear Technology 功能描述:200mA, 36V DC/DC μModule
LTM8021 制造商:LINER 制造商全称:Linear Technology 功能描述:36VIN, 600mA Step-Down μModule Converter